The set screw helps keep the handle in place when you rotate it to open the door.
Fix loose door handle screws.
Once triggered the lever or lock trim can be removed from the door.
When dealing with a lever door handle fixing the problem will require only the most basic of tools and about 10 minutes of time.
To depress the detent use the end of a metal paper clip or the point of an awl inserting it into the hole and pressing the detent down while twisting and removing the door handle shaft off the spindle.
Levers handles slide onto a rod assembly with a set screw.
If any screws are exposed during this process remove them to release the lock and remove it from the door.
This type is found commonly on lever style door handles.
Release the tab or button remove the inside doorknob by locating the button like our model metal tab or wire clip on the side of the knob that acts as a release.
However before you begin to do this you should take the time to adequately determine which type of door knob you have in place.
A loose lever requires some readjustment to properly fit into the rod assembly.
Using an awl or small screwdriver push the button in all the way and at the same time pull off the handle.
If it is a threaded shaft you will have to twist the shaft s handle to make it flush with the door.
This type is usually found on round doorknob hardware.
To adjust the screw or allen key look around the collar on the doorknob to identify the loose screw and using the appropriate screwdriver tighten the screws.
Tighten a loose door handle photo 1.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
This screw fits in a groove on the round lever rod.
If exposed screws are being used you will have to find the set screw which is normally found on the inside of the door.
Using either a screwdriver or allen key loosen the set screw and remove the handle which will uncover the shaft.
Straighten a paper clip and insert it into the hole.
In order to tighten the screws in a loose door knob or loose door handle you need to work on removing your loose door knob or loose door handle from the door that it is currently on.
If the shaft is threaded then twist the handle on the shaft until it is flush with the door.
If a doorknob loosely spins on the spindle the cause is usually that a set screw similar to a grub screw has loosened up and has lost its grip on the handle spindle.
